H2o transfer printing movies include a clear layer of polyvinyl alcohol (PVA), that is printed by using a selection of decorations. The ink layer is then sealed. The PVA layer dissolves on speak to with water. Thereafter, the seal is dissolved by an activator (a specific form of solvent) and only the colour layer continues to be. The paint layer adheres on the workpiece immersed and behaves like a lacquer layer following drying.
The best h2o temperature to the technique of printing water movies is 32 ° C. In chilly weather conditions as much as 34 ° Celsius.
The transfer water transfer film ought to be minimize on all sides at a length of 1 cm to forestall winding when placing about the floor in the h2o. You should do not persist with tape because the movie can not rise during the immersion process (In case the PVA is dissolved, the film "relaxes" along with the floor dimension will increase minimally).
Right after the required exposure time, spray the movie at a distance of 20-30 cm inside the course of crossover with activator of 25 to 45 g / m² (based on the purpose, because highly printed films want much more activator).
The workpiece can be immersed soon after approx. 15 seconds.
All parts which are not made from Ab muscles plastic should be well prepared before diving (eg by lacquering).
After approx. A single minute, the workpiece needs to be washed with sizzling drinking water at 42 ° C (do not utilize a powerful drinking water jet, parts of the movie may dissolve).
The coloration proven could differ from your authentic film with regards to the output gadget. For any result which is akin to the image, the color recommendation qualifications must match the selected h2o transfer print film.
The best h2o temperature to the technique of printing water movies is 32 ° C. In chilly weather conditions as much as 34 ° Celsius.
The transfer water transfer film ought to be minimize on all sides at a length of 1 cm to forestall winding when placing about the floor in the h2o. You should do not persist with tape because the movie can not rise during the immersion process (In case the PVA is dissolved, the film "relaxes" along with the floor dimension will increase minimally).
Right after the required exposure time, spray the movie at a distance of 20-30 cm inside the course of crossover with activator of 25 to 45 g / m² (based on the purpose, because highly printed films want much more activator).
The workpiece can be immersed soon after approx. 15 seconds.
All parts which are not made from Ab muscles plastic should be well prepared before diving (eg by lacquering).
After approx. A single minute, the workpiece needs to be washed with sizzling drinking water at 42 ° C (do not utilize a powerful drinking water jet, parts of the movie may dissolve).
The coloration proven could differ from your authentic film with regards to the output gadget. For any result which is akin to the image, the color recommendation qualifications must match the selected h2o transfer print film.
Verify out this site: http://cursopinturahidrografica-wtp.com
Nenhum comentário:
Postar um comentário